Changing front wheel bearings

[soundcontrol]

Gonna change the front wheel bearings on my Barracuda, since one is making a slight noise.
Now, the area in between the inner and outer bearing, should that be completely filled with grease?
Big cavity there and fits a lot of grease. 30 years since I changed a wheel bearing and I don't remember.

[GoodysGotaCuda]

I don't see a need, it won't work it's way into either bearing. Just clean, pack each bearing, install the rear seal and assemble. 

[anlauto]

I don't see a need, it won't work it's way into either bearing. Just clean, pack each bearing, install the rear seal and assemble. 

[dodj]

 It's not filled. Coat interior surfaces with grease. Like about 5mm thick.

[RUNCHARGER]

I've always found them lightly coated so I have always done the same. I suppose it would pick up any grit in there and hold it although I don't know where grit would come from.

[MoparLeo]

Just a note. If you look in your factory service manual in the axle and bearing section, it says to fill the grease cavity on both disc and drum brake hubs. Just in case you want to follow factory guidelines.

[Chryco Psycho]

Depends how you drive you car I guess , I have always put a lot of grease in the middle , not full but enough that as it heats up it can flow over into the brgs , this can help in road racing or autocross events where you can put a lot of side load on the brgs .
Have I mentioned I love to corner hard most of the time 
Nothing more fun than entering a corner with someone on your rear bumper & coming out of the corner with a train length between you or watching some one slide of the road trying to keep up because they chicken out & touch the brakes !! I have passed Porsches in mountain corners in a friggin Mopar mini van Yes I have wide low profile tires on the mini van but still   

[dodj]

Just a note. If you look in your factory service manual in the axle and bearing section, it says to fill the grease cavity on both disc and drum brake hubs. Just in case you want to follow factory guidelines.

Not in my '73 manual. It says to coat the cavity, not fill it. 

[Bullitt-]

 I was told long ago not to pack the cavity full to allow for the grease to expand otherwise it would push it's way out..   Makes sense to me still. 

[bc3j]

My '70 manual on page 0-22 cautions against overfilling.

[YellowThumper]

Pack the bearings themselves. Palm trick works well.
Can coat the inner but is not necessary. As previously noted. Expansion and I would guess. Centrifugal force would make a mess of things as it ooses out.

[RUNCHARGER]

Manual is exactly how I do it. That's probably why I have been doing it that way I would guess.

[MoparLeo]

Don't over fill the cap.That rease is just excess as the grease from inside the hub area would feed through the bearings before it could escape out of the seals or dust cap. That is the reason there is a place for it.