Modern Hemi Swaps

B

Mystery Container ? Can someone tell me what tis container is for ?I've installed (3) 392's now and never seen this befo...

Started by anlautoView the profile of anlauto

Replies: 7
Views: 1,323

April 19, 2023, 01:10:54 PM
by Burdar

B

Brake Pedal Switch Advice Can anyone tell me how you installed the brake pedal switch on your conversion? I have a 2017 5.7 wi...

Started by SFEBODYView the profile of SFEBODY

Replies: 4
Views: 1,404

April 11, 2023, 07:34:44 PM
by Bobbydodge

Battery wire gauge What size wire are you using from trunk to PDU/starter?Having an issue with hot starts.Car won't sta...

Started by KatfishView the profile of Katfish

Pages1 2

Replies: 21
Views: 3,427

February 12, 2023, 04:57:11 AM
by dodj

7

Gen 3 starter question So I went to put my mini starter on and found out my starter hit the raised boss on the drivers side...

Started by 71340RTView the profile of 71340RT

Replies: 8
Views: 1,405

January 05, 2023, 07:21:57 AM
by 74-5.7

1973 Challenger Gen 3 Hemi swap I had a 1974 Challenger with a 5.7 Hemi and sold it back to the guy who started the build a little o...

Started by 71340RTView the profile of 71340RT

Pages1 2

Replies: 25
Views: 6,299

January 03, 2023, 10:05:30 PM
by 360fish

F

What flywheel and clutch Can someone tell me what flywheel and clutch comes on the 6.4 crate motors?https://www.rosevillemopa...

Started by Filthy FilbertView the profile of Filthy Filbert

Replies: 12
Views: 1,607

December 09, 2022, 11:35:37 AM
by Filthy Filbert

C

Alternator for 2011 and up car front cover I'm looking to order an alternator for my Cuda.  I did not notch my frame rail, but now I have switc...

Started by Swamp DonkeyView the profile of Swamp Donkey

Replies: 4
Views: 944

December 06, 2022, 09:21:20 AM
by CudaA39

Alternate spot to mount horns? I see some swaps have cleaned up the engine compartment.Any pics/suggestions on where to mount the h...

Started by KatfishView the profile of Katfish

Replies: 7
Views: 925

November 09, 2022, 07:26:59 AM
by anlauto

F

Holley G3 swap Blackheart motor mounts I'm going to be using the Holley Blackheart Gen3 hemi swap mount plates on my 392 crate motor for my...

Started by 71340RTView the profile of 71340RT

Pages1 2

Replies: 20
Views: 4,106

November 03, 2022, 08:01:28 AM
by Filthy Filbert

Where to vent gas tank? I had fuel injection, with pump in tank for my 340.Ran the vent line to the PCV on the valve cover o...

Started by KatfishView the profile of Katfish

Replies: 7
Views: 1,191

October 30, 2022, 11:32:57 AM
by Dakota

R

Battery Relocation, Vintage Air, Hotwire Harness I'm keeping this thread separate from my regular one in an attempt to understand how the original wi...

Started by rebelyellView the profile of rebelyell

Pages1 2

Replies: 23
Views: 1,984

October 28, 2022, 05:37:19 AM
by rebelyell

Close, but no start, stumped 5.7 crate motor with Mopar harnessTried first start and no dice.I wired it up to use the factory 70 ...

Started by KatfishView the profile of Katfish

Replies: 7
Views: 968

October 25, 2022, 06:00:59 PM
by Chryco Psycho

5.7 Hemi Supercharged + 8HP70 restomod project questions Hey everyone,My first post here - I have taken over a 1970 Cuda project which has been sitting still...

Started by speedbird1229View the profile of speedbird1229

Replies: 1
Views: 717

October 22, 2022, 11:07:33 AM
by Chryco Psycho

D

DLC mounting location and codes? 2 part question, I'm close to first start on my swap.1) where did you mount the DLC used to read eng...

Started by KatfishView the profile of Katfish

Replies: 3
Views: 694

October 07, 2022, 09:30:06 AM
by Dmod1974

R

6.1 Swap Recently got a good deal on a 6.1 Hemi, so I'm going to use this thread to plan out the swap and pos...

Started by rebelyellView the profile of rebelyell

Pages1 2 3 4

Replies: 57
Views: 6,663

September 20, 2022, 05:34:41 AM
by rebelyell

F

Hemi Motor mount recommendation? Hi,Looking for advice on 5.7 eagle swap. Planning to use 833 trans, Borgeson steering, factory manif...

Started by b5cudaView the profile of b5cuda

Replies: 8
Views: 1,229

August 31, 2022, 05:31:13 AM
by Filthy Filbert

Questions for those that have Hellcat swapped their E-bodies For years I have been conflicted as to whether or not I want to modern hemi swap my 72 Challenger. I...

Started by 72hemiView the profile of 72hemi

Replies: 7
Views: 1,163

August 10, 2022, 08:35:20 PM
by JpRngr

GEN III Hemi question ??? So on my crate motor there's an open tube on the intake....I thought it was just a stanchion to supp...

Started by anlautoView the profile of anlauto

Replies: 8
Views: 947

August 09, 2022, 07:28:16 AM
by Mybrothers70

7

Ignition start wiring Want to verify this will work.  I've seen other threads, but just couldn't wrap my head around it.I ...

Started by KatfishView the profile of Katfish

Replies: 1
Views: 931

July 16, 2022, 09:50:05 AM
by 74-5.7

Stock gauges with hemi swap Quick question!!! How are u guys wiring your stock gauges with a hemi swap??? I also rewired my car ...

Started by Cuda70-74View the profile of Cuda70-74

Replies: 7
Views: 1,379

June 30, 2022, 04:54:26 AM
by Cuda70-74